Installing The Mounting Hardware - Juniper SRX5600 Installation And Initial Configuration Manual

Installing the Mounting Hardware

http://www.juniper.net/techpubs/hardware/.
• On the rear of each rack rail, partially insert a mounting screw into the rack hole 17.26
inches above the "U" division which will align with the bottom of the SRX5800.
• Install the large shelf on the rack. Hang the shelf over the mounting screws using the
keyhole slots located near the top of the large shelf flanges.
• Partially insert screws into the open holes in the ears of the large shelf. Tighten the • Partially insert screws into the open holes in the ears of the large shelf Tighten the
screws until the mounting shelf fits tightly on the rack.
© 2010 Juniper Networks, Inc. All rights reserved.
CONFIDENTIAL
www.juniper.net | 28
FSSSRX5800