Table of Contents
Advertisement
2. Using the Command Line Interface
Configuring the Unit for Operation
Once the unit is connected to the network, the following turn-up procedures should
be performed:
T
T
Optionally, you may also choose to do the following using the EMS:
T
T
Additional Configuration Commands
Additional configuration is necessary if you do not choose to accept the defaults
that have been automatically assigned to your GranDSLAM 4200.
Additional TL1 commands that you may need are listed in
GranDSLAM 4200 Configuration
also be configured using the EMS (see the
Table 2-2.
2-8
5. Enable security for your GranDSLAM 4200 unit. Using the TL1 command
ENT-USER-SECU, change the default login and password. Use the EMS to
configure SNMP community strings, the SYSLOG server, and trap managers.
6. Change the time, if necessary. The Simple Network Time Protocol (SNTP),
which maintains the unit's clock, defaults to enabled for multicast. However,
you can change the time offset from Coordinated Universal Time (UTC) using
the TZOFFSET parameter of the SET-NE-ALL TL1 command. See
SET-NE-ALL
in Chapter 14, System Commands for more information.
Change the login and password using the ED-USER-SECU TL1 command
from the defaults SUPERUSER, ASN#1500.
Change the SNMP community strings using the EMS.
Configure the syslog server at the NOC.
Configure the trap managers.
GranDSLAM 4200 Configuration Commands
To . . .
Configure data
associated with the
T1/DS1 facility
Manually configure an
Internet Protocol (IP)
address (Manual mode)
Set miscellaneous
configuration parameters,
in particular the use of
,
SNTP
(defaults to
enabled)
Retrieve a list of equipped
units
August 2002
Commands. The ADSL and ATM profiles can
GrandVIEW EMS 3.0 User's Guide
Enter this command . . .
ENT-T1:[tid]:NTT1-circuit:[ctag]:::ds1_nblk:
[pst];
ENT-IPPORT:[tid]:ATM-1:[ctag]::MANUAL:ipport_
nblk:[pst];
SET-NE-ALL:[tid]:[aid_com]:[ctag]:::ne_nblk;
RTRV-EQPT:[tid]:ALL;
Table 2-2,
).
4200-A2-GB20-00
Advertisement
Chapters
Table of Contents
