Table of Contents
Advertisement
RTRV-ATUR
The RTRV-ATUR command retrieves operational parameters configured for the
ADSL ATU-R.
Table 3-27. RTRV-ATUR Command Parameters
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
After the above response, a new command input may be generated.
Normal Response:
M
;
Error Response:
M
;
4200-A2-GB20-00
RTRV-ATUR:[tid]:aid_atur:[ctag];
RESTRICTIONS: All parameters in this command are position-defined.
[tid]
Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_atur
Access identifier for an ADSL line. The value can be preceded with
AID=, but this is not required. Grouping and ranging are allowed. Enter
in the following format, replacing lower-case parameters with the values
given:
ATUR-rack-shelf-slot-circuit
rack: Rack number (1)
shelf: Shelf number (1)
slot: LT slot number (1)
circuit: ADSL circuit on the LT (1 24)
[ctag]
Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
IP c
sid yy-mm-dd hh:mm:ss
c COMPLD
/* RTRV-ATUR:[tid]:aid_atur:[ctag] */
aid_atur:atur_nblk
sid yy-mm-dd hh:mm:ss
c
DENY
/* RTRV-ATUR:[tid]:aid_atur:[ctag] */
errcde
August 2002
3. ADSL Facility Commands
3-35
Advertisement
Chapters
Table of Contents
