Table of Contents
Advertisement
ED-PROFILE-ADSLUP
The ED-PROFILE-ADSLUP command enables you to edit ADSL line configuration
parameters for the upstream direction (from ATU-R to ATU-C) in an ADSL Profile.
See
ADSL profile.
Table 3-15. ED-PROFILE-ADSLUP Command Parameters
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
After the above response, a new command input may be generated.
Normal Response:
M
ED-PROFILE-ADSLUP:[tid]:adsl_profile_id:[ctag]:::[adslprof_n
blk] */
;
4200-A2-GB20-00
ENT-PROFILE-ADSL
ED-PROFILE-ADSLUP:[tid]:adsl_profile_id:[ctag]:::[adslprof_
nblk];
RESTRICTIONS: All parameters in this command are position-defined.
[tid]
Identification of the target NE. TID is optional and has an default value
of null. The NE's SID code is the only other valid value.
adsl_profile_id
Numeric identifier of a profile (1 30).
[ctag]
Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
[adslprof_nblk]
ADSL parameter block containing one or more of the following named
parameters (separated by commas):
PFBR: Planned Fast Channel Bit Rate in kbps (32 2176).
MAXFBR: Maximum fast-channel bit rate in kilobits per second
(32 2176). The default is 2176. Range and default vary per model.
MINFBR: Minimum fast-channel bit rate in kilobits per second (32). The
default is 32. Range and default vary per model.
TNMR: Target noise margin (3 14 dB). Default is 4 dB.
If not specified, the values of these parameters remain unchanged.
IP c
sid yy-mm-dd hh:mm:ss
c COMPLD
/*
August 2002
on page 3-24 for information on how to create a new
3. ADSL Facility Commands
3-19
Advertisement
Chapters
Table of Contents
