Ed-Atmport; Response Format - Paradyne GranDSLAM 4200 User Manual

5. ATM Commands

ED-ATMPORT

The ED-ATMPORT command edits configuration data associated with an ATM
port in the NE.
Table 5-5.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
After the above response, a new command input may be generated.
Normal Response:
M
*/
;
Error Response:
M
*/
;
5-6
ED-ATMPORT Command Parameters
ED-ATMPORT:[tid]:aid_atmport:[ctag]:::[atmport_nblk];
RESTRICTIONS: All parameters in this command are position-defined.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_atmport Access Identifier for an ATM port. The value can be preceded with
AID=, but this is not required. Grouping and ranging are allowed. Enter
any of in the following formats, replacing lower-case parameters with
the values given:
NTATM: ATM port in the NT
LTATM-rack-shelf-slot-circuit: ATM port for an LT circuit
– rack: Rack number (1)
– shelf: Shelf number (1)
– slot: LT slot number (1)
– circuit: ADSL circuit on the LT (1 24)
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
IP c
sid yy-mm-dd hh:mm:ss
c COMPLD
/* ED-ATMPORT:[tid]:aid_atmport:[ctag]:::[atmport_nblk]
sid yy-mm-dd hh:mm:ss
c DENY
/* ED-ATMPORT:[tid]:aid_atmport:[ctag]:::[atmport_nblk]
aid:ERRCDE=errcde
/* error description */
August 2002 4200-A2-GB20-00