Atm Vcl Configuration Group (Rfc 2515) - Paradyne GranDSLAM 4200 User Manual

C. Traps and MIBs

ATM VCL Configuration Group (RFC 2515)

Contains configuration and state information of a bidirectional VCL at an ATM
interface. The atmVclEntry is supported as shown in
MIB Group
Table C-7. VCL Configuration MIB Group Objects
Object
atmVclOperStatus
(atmVclEntry 4)
atmVclLastChange
(atmVclEntry 5)
atmVccAalType
(atmVclEntry 8)
atmVccAal5CpcsTransmit
SduSize (atmVclEntry 9)
atmVccAal5CpcsReceive
SduSize (atmVclEntry 10)
atmVclEncapsType
(atmVclEntry 11)
C-16
Objects.
Description
Operational status of the VCL.
Contains the value of the sysUpTime
object at the time the VCL entered its
current operational state.
Identifies the type of AAL used with the
VCC.
Contains the maximum Common Part
Convergence Sublayer SDU size
supported in the transmit direction of
this VCC.
Contains the maximum Common Part
Convergence Sublayer SDU size
supported in the Receive direction of
this VCC.
Specifies the type of data encapsulation
used over the AAL5 Service Specific
Convergence Sublayer.
August 2002
Table C-7, VCL Configuration
Setting/Contents
Possible values are:
T
up(1): VCL is currently operational
T
down(2): VCL is currently not operational
T
unknown(3): The state of the VCL cannot
be determined.
Integer. If the current state was entered into
prior to the last reinitialization of the agent,
then this object contains a zero value.
The only valid values are:
T
aal5(3): AAL5
T
unknown(5): The AAL type cannot be
determined.
Not supported.
Not supported.
Not supported.
4200-A2-GB20-00