Ent-Vcl - Paradyne GranDSLAM 4200 User Manual

5. ATM Commands

ENT-VCL

The ENT-VCL command creates an ATM interface Virtual Channel Links (VCL) on
an NT or LT.
Table 5-9.
5-10
ENT-VCL Command Parameters
ENT-VCL:[tid]:aid_vcl:[ctag]::[rcv_trafdsc],[xmt_trafdsc],[
rcv_trafdscnm],[xmt_trafdscnm];
RESTRICTIONS: All parameters in this command are position-defined. If the VCL or VPI is
unavailable or in use, or the resources specified by the receive or transmit traffic descriptor
are not available, the command fails.
[tid] Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_vcl Virtual Circuit Identifier for the Virtual Circuit. The value can be
preceded with AID=, but this is not required. Grouping and ranging are
allowed. Enter any of in the following formats, replacing lower-case
parameters with the values given:
NTVCL-vpi-vci: VCL in the NT
LTVCL-rack-shelf-slot-circuit-vpi-vci: VCL in an LT circuit
– rack: Rack number (1)
– shelf: Shelf number (1)
– slot: LT slot number (1)
– circuit: DSL circuit on the LT (1 24)
– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0 15)
– vci: Virtual Channel Identifier (for LT vpi=32 63,
for NT vpi=32 1023)
[ctag] Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
1
[rcv_trafdsc] Receive traffic descriptor profile index (1 250).
1
[rcv_trafdscnm] Receive traffic descriptor profile name. If a local profile and network
profile both match this name, the network profile is used.
2
[xmt_trafdsc] Transmit traffic descriptor profile index (1 250).
2
[xmt_trafdscnm] Transmit traffic descriptor profile name. If a local profile and network
profile both match this name, the network profile is used.
1
Either rcv_trafdsc or rcv_trafdscnm must be entered, but not both.
2
Either xmt_trafdsc or xmt_trafdscnm must be entered, but not both.
August 2002 4200-A2-GB20-00