Table of Contents
Advertisement
3. ADSL Facility Commands
ENT-PROFILE-ADSL
The ENT-PROFILE-ADSL command allocates a new ADSL line configuration
profile. A new ADSL profile is created using the following steps:
Table 3-19. ENT-PROFILE-ADSL Command Parameters
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
After the above response, a new command input may be generated.
Normal Response:
M
profile_name */
;
3-24
1. Allocate a new profile with ENT-PROFILE-ADSL.
2. Configure downstream transmission parameters with ED-PROFILE-ADSLDN.
3. Configure upstream transmission parameters with ED-PROFILE-ADSLUP.
4. Activate the profile with ACT-PROFILE-ADSL.
5. Apply the profile to a port with ED-ADSL.
ENT-PROFILE-ADSL:[tid]:[adsl_profile_id]:[ctag]::profile_na
me,,[latency];
RESTRICTIONS: Valid only for profiles with LOCAL scope. All parameters in this
command are position-defined.
[tid]
Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
adsl_profile_id
ADSL profile index (1 30). The profile must not already be in use.
Profile 1 (a predefined profile shipped with the system) is the default
and is always active. If no profile is entered, the next available profile
index will be assigned. If an index is entered, it must be the next
available index.
[ctag]
Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
profile_name
Name (1 32 characters) that uniquely identifies the profile
latency
Latency of the ADSL line. Only single latency is supported upstream
and downstream. The valid value is FAST (only ADSL FAST
supported).
IP c
sid yy-mm-dd hh:mm:ss
c COMPLD
/* ENT-PROFILE-ADSL:[tid]:adsl_profile_id:[ctag]::
August 2002
4200-A2-GB20-00
Advertisement
Chapters
Table of Contents
