Act-User; Response Format - Paradyne GranDSLAM 4200 User Manual

14. System Commands

ACT-USER

The ACT-USER command logs a user on and begins a user session.
Table 14-1.

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response will be sent:
After the above response, a new command input may be generated.
Normal Response:
M
;
Error Response:
M
;
14-2
ACT-USER Command Parameters
ACT-USER:[tid]:[uid]:[ctag];;pid;
RESTRICTIONS: All parameters in this command are position-defined. A maximum of
four remote (telnet) sessions and one console terminal session may be logged on
simultaneously.
[tid] The identification of the target NE. TID is optional and has a factory
default value of null. The NE's SID code is the only other valid value.
[uid] The user identification name (10 characters maximum). Input is
case-sensitive. Grouping is not allowed.
[ctag] The correlation tag (6 characters maximum) that links an input
command with associated output responses. It is optional with a default
of 0.
[pid] The user identification name (10 characters maximum). Must include at
least one letter, one digit, and one nonalphanumeric character. Input is
case-sensitive. Grouping is not allowed.
IP c
sid yy-mm-dd hh:mm:ss
c COMPLD
/* ACT-USER:[tid]:uid:[ctag]::pid */
NOTE:
In this response, the pid is displayed as a series of asterisks.
sid yy-mm-dd hh:mm:ss
c DENY
August 2002 4200-A2-GB20-00