Table of Contents
Advertisement
RTRV-VCL
The RTRV-VCL command retrieves configuration data associated with an ATM
virtual channel link.
Table 5-17. RTRV-VCL Command Parameters
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
After the above response, a new command input may be generated.
4200-A2-GB20-00
RTRV-VCL:[tid]:aid_vci:[ctag]::::[pstf],[sstf];
RESTRICTIONS: All parameters in this command are position-defined.
[tid]
Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_vci
Virtual Circuit Identifier for the Virtual Circuit. The value can be
preceded with AID=, but this is not required. Grouping and ranging are
allowed. Enter any of in the following formats, replacing lower-case
parameters with the values given:
NTVCL-vpi-vci: VCL in the NT
LTVCL-rack-shelf-slot-circuit-vpi-vci: VCL in an LT circuit
– rack: Rack number (1)
– shelf: Shelf number (1)
– slot: LT slot number (1)
– circuit: DSL circuit on the LT (1 24)
– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0 15)
– vci Virtual Channel Identifier (for LT vpi=32 63,
for NT vpi=32 1023)
[ctag]
Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
pstf
Primary State Filter. If no value is specified, this filter is ignored. Valid
values are:
IS: In Service
OOS: Out Of Service
sstf
Secondary State Filter. The only valid value is LPBK (loopback).
IP c
August 2002
5. ATM Commands
5-21
Advertisement
Chapters
Table of Contents
