Response Format - Paradyne GranDSLAM 4200 User Manual

10. Fault Commands

Response Format

If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response will be sent:
After the above response, a new command input may be generated.
Normal Response:
M
[cond_dsl1],[locn],[dirn] */
;
Error Response:
M
RTRV-ATTR-T1:[tid]:aidall_t1:[ctag]::[ntfncde],[cond_adsl],
[locn],[dirn] */
;
Table 10-16. RTRV-ATTR-T1 Response Parameters (1 of 2)
10-26
IP c
sid yy-mm-dd hh:mm:ss
c COMPLD
/* RTRV-ATTR-T1:[tid]:aidall_t1:[ctag]::[ntfncde],
"aidall_adsl,aid_type:ntfncde,cond_t1,[locn],[dirn]"
sid yy-mm-dd hh:mm:ss
c DENY
/*
errcde
Parameter Explanation
tid Target NE identification
yy-mm-dd Year, month, and day
hh:mm:ss Hour, minute, and second
M Message generated in response to an input command
c If provided, ctag; otherwise 0
COMPLD Completed
DENY Input command is denied
/* */ Enclosed are human readable comments – unspecified format
errcde Error code (see
aidall_t1 As described for command parameters (see
RTRV-ATTR-T1 Command
aid_type The type of Access Identifier. The value is T1.
ntfncde As described for command parameters (see
RTRV-ATTR-T1 Command
cond_ds1 As described for command parameters (see
RTRV-ATTR-T1 Command
August 2002
Appendix A, Error Codes )
Parameters), except that ALL is not used.
Parameters), except that ALL is not used.
Parameters).
Table 10-15,
Table 10-15,
Table 10-15,
4200-A2-GB20-00