Table of Contents
Advertisement
5. ATM Commands
DLT-VCL
The DLT-VCL command deletes selected ATM interface Virtual Channel Links
(VCL) that are not in use.
Table 5-3.
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
After the above response, a new command input may be generated.
Normal Response:
M
;
5-4
DLT-VCL Command Parameters
DLT-VCL:[tid]:aid_vcl:[ctag][:];
RESTRICTIONS: All parameters in this command are position-defined. If the VCL is
cross-connected, the deletion fails.
[tid]
Identification of the target NE. The default value is null. The NE SID
code is the only other valid value.
aid_vcl
Virtual Circuit Identifier for the Virtual Circuit. The value can be
preceded with AID=, but this is not required. Grouping and ranging are
allowed. Enter any of in the following formats, replacing lower-case
parameters with the values given:
NTVCL-vpi-vci: VCL in the NT
LTVCL-rack-shelf-slot-circuit-vpi-vci: VCL in an LT circuit
– rack: Rack number (1)
– shelf: Shelf number (1)
– slot: LT slot number (1)
– circuit: DSL circuit on the LT (1 4)
– vpi: Virtual Path Identifier (for LT vpi=0, for NT vpi=0 15)
– vci Virtual Channel Identifier (for LT vpi=32 63,
for NT vpi=32 1023)
[ctag]
Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
IP c
sid yy-mm-dd hh:mm:ss
c COMPLD
/* DLT-VCL:[tid]:aid_vcl:[ctag][:] */
August 2002
4200-A2-GB20-00
Advertisement
Chapters
Table of Contents
