Table of Contents
Advertisement
3. ADSL Facility Commands
RTRV-PROFILE-ADSLUP
The RTRV-PROFILE-ADSLUP command enables you to retrieve ADSL line
configuration parameters associated with the upstream direction (from ATU-R to
ATU-C) in an ADSL Profile. See
information on how to create a new ADSL profile.
Table 3-39. RTRV-PROFILE-ADSLUP Command Parameters
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response is sent:
After the above response, a new command input may be generated.
Normal Response:
M
RTRV-PROFILE-ADSLUP:[tid]:adsl_profile_id:[ctag]:[::,profile
_scope] */
;
Error Response:
M
RTRV-PROFILE-ADSLUP:[tid]:adsl_profile_id:[ctag][::profile_
scope] */
;
3-50
RTRV-PROFILE-ADSLUP:[tid]:adsl_profile_id:[ctag][::,profile
_scope];
RESTRICTIONS: All parameters in this command are position-defined.
[tid]
Identification of the target NE. TID is optional and has a default value of
null. The NE's SID code is the only other valid value.
adsl_profile_id
Numeric identifier of a profile (1 30).
[ctag]
Correlation tag (6 characters maximum) that links an input command
with associated output responses. The default is 0.
profile_scope
The scope of a profile. The valid value is LOCAL (local to this stack
only). If no parameter is specified, this value is ignored (all values are
reported).
IP c
sid yy-mm-dd hh:mm:ss
c COMPLD
/*
adsl_profile_id:profile_scope:profile_name:adslprof_nblk
sid yy-mm-dd hh:mm:ss
c
DENY
/*
errcde
August 2002
ENT-PROFILE-ADSL
on page 3-24 for
4200-A2-GB20-00
Advertisement
Chapters
Table of Contents
