Set-Sid - Paradyne GranDSLAM 4200 User Manual

SET-SID

The SET-SID command sets the system identifier (SID) of a network element.
Table 14-27. SET-SID Command Parameters
Response Format
If, in less than 2 seconds, a normal or error response cannot be sent, the following
acknowledgment response will be sent:
After the above response, a new command input may be generated.
Normal Response:
M
;
Error Response:
M
;
4200-A2-GB20-00
SET-SID:[tid]::[ctag]::sid;
RESTRICTIONS: All parameters in this command are position-defined.
[tid] The identification of the target NE. TID is optional and has a default
value of null. The NE's SID code is the only other valid value.
[ctag] The correlation tag that correlates an input command with its associated
output response(s). It is assigned by the originator of the command. The
value is limited to six characters, which may be an identifier or a decimal
numeral. It is optional with a default of 0.
sid System identifier. A text string of up to 16 characters that uniquely
identifies the NE.
IP c
sid yy-mm-dd hh:mm:ss
c COMPLD
/* SET-SID:[tid]::[ctag]::sid */
sid yy-mm-dd hh:mm:ss
c DENY
/* SET-SID:[tid]::[ctag]::sid */;
errcde
August 2002
14. System Commands
14-35