Agilent Technologies Agilent 33500 Series Operating And Service Manual page 49

Set Up Arbitrary Waveform
7. Notice that the first softkey, Select Point # is highlighted. Put the marker on the 270th waveform point by using
the numeric keypad to enter the number 270 and pressing Enter.
8. Press Choose Wave, select Square, and then press OK. Set the Amplitude to 3 V, the Offset to -2 V, the Cycles
to 8, and the Points to 100. Press OK. Notice that the 8 square wave cycles have been inserted, beginning at the
marker. Press Done.
Edit Waveform Characteristics
1. Press Edit Params and then set the Sampling Rate to 100 Sa/s. Press Cycle Period and notice that it has been
set to 4.08 seconds. This is because you have 408 sample points in the waveform, and the sample rate is 100
Sa/s.
48 Agilent 33500 Series Operating and Service Guide