Agilent Technologies Agilent 33500 Series Operating And Service Manual page 360

-222 List Data out of range; Sine frequency : Mode is changed to continuous wave
-222 List Data out of range; Square frequency : Mode is changed to continuous wave
-222 List Data out of range; user frequency : Mode is changed to continuous wave
-221 Setting the advance mode to trigger forced the trigger source to external.
-221 Setting the Arb Filter OFF changed the maximum sample rate value to 6.25e7.
-221 Setting the trigger source changed the arb advance mode.
-221 Settings conflict;
50V input range not compatible with 50 ohm input impedance; impedance set to 1 Mohm
AM depth forced amplitude change
AM turned off by selection of other mode or modulation
amplitude changed due to function
amplitude changed due to offset
amplitude units changed to Vpp due to high-Z load
amplitude units changed to Vpp, dBm and Vrms not applicable to arb sequences
amplitude units unchanged, dBm and Vrms not applicable to arb sequences
arb advance changed to SRATE due to mode
arb voltage reduced due to output load or limits
both edge times decreased due to period
both edge times decreased due to pulse duty cycle
both edge times decreased due to pulse width
BPSK turned off by selection of other mode or modulation
burst count reduced to fit entire burst
Burst mode has caused output phase to be set to zero degrees
burst period increased to fit entire burst
burst phase inapplicable for arbs larger than 1M. burst phase set to 0
burst turned off by selection of other mode or modulation
cannot delete state selected and enabled for automatic power-on recall
Cannot modulate ARB carrier with ARB as modulation function. Modulation turned off.
Cannot modulate ARB carrier with ARB modulation function. Function unchanged.
Cannot modulate ARB carrier with USER as modulation function. Modulation turned off.
Cannot modulate ARB carrier with USER modulation function. Function unchanged.
Cannot modulate Noise carrier with Noise as modulation function. Modulation turned off.
Cannot modulate Noise carrier with Noise modulation function. Function unchanged.
Cannot modulate PRBS carrier with PRBS as modulation function. Modulation turned off.
Agilent 33500 Series Operating and Service Guide
SCPI Error Messages
359