Agilent Technologies Agilent 33500 Series Operating And Service Manual page 245

MARKer Subsystem
MARKer Subsystem
The MARKer subsystem configures the point within an arbitrary waveform, sweep, or burst at which the front-panel
Sync signal goes low.
Commands and Queries
MARKer:CYCle - cycle of a burst at which Sync signal goes low
l
MARKer:FREQuency
l
MARKer:POINt - point in an arbitrary waveform at which Sync signal goes low
l
Each of these commands causes sync/marker to transition to high at start of burst, sweep, or arbitrary waveform
Put:SYNC:POLarity may reverse this.).
[SOURce[1|2]:]MARKer:CYCLe {< cycle_num >|MINimum|MAXimum}
[SOURce[1|2]:]MARKer:CYCLe? [{MINimum|MAXimum}]
Sets the marker cycle number at which the front-panel Sync signal goes low in a burst mode operation.
Put:SYNC:POLarity may reverse this..
Whole number from 2 to number of cycles in the burst plus one (NCYCles+1),
default 2
Set the marker cycle to 2000:
MARK:CYCL 2000
This is valid only if burst is enabled and
l
With burst enabled, marker cycle must be less than number of cycles in burst plus one. Attempting to set the
l
marker cycle outside this range will set marker cycle equal to middle of burst. From the remote interface, a "Set-
tings conflict" error will also be generated.
[SOURce[1|2]:]MARKer:FREQuency {< frequency >|MINimum|MAXimum}
[SOURce[1|2]:]MARKer:FREQuency? [{MINimum|MAXimum}]
Sets the marker frequency at which the front-panel Sync signal goes low during a sweep.
reverse this..
Any frequency between start and stop frequency, default 500 Hz
Set marker frequency to 2 kHz:
MARK:FREQ 2000
This is valid only if burst is enabled and
l
244
- frequency at which Sync signal goes low
Parameter
OUTP:SYNC:MODE
Parameter
OUTP:SYNC:MODE
is MARKer.
Typical Return
+2.000000000000000E+03
is MARKer.
Agilent 33500 Series Operating and Service Guide
OUT-
Typical Return
+2.000000000000000E+03
OUTPut:SYNC:POLarity
(OUT-
may