Agilent Technologies Agilent 33500 Series Operating And Service Manual page 121

Remote Interface Configuration
Resetting the LAN
You can clear the Web Interface password, turn DHCP on, and restart the LAN at any time:
Front panel:
l
The message "Performing LAN Reset" is displayed while the LAN is reset.
SCPI: (No equivalent command)
l
DHCP On/Off
DHCP (Dynamic Host Configuration Protocol) can automatically assign a dynamic IP address to a LAN device. Typically
easiest way to configure instrument for LAN.
This setting is non-volatile; it will not be changed by power cycling or *RST.
l
Front Panel:
l
Finally, toggle the first softkey to DHCP to use DHCP to automatically assign an IP address.
SCPI: SYSTem:COMMunicate:LAN:DHCP <state>
l
To manually set an IP address, Subnet Mask, or Default Gateway, turn DHCP off, then change IP setup as described
below.
IP Address
You can enter a static IP address for the instrument as a four-byte integer expressed in dot notation. Each byte is a dec-
imal value, with no leading zeros (for example, 169.254.2.20).
If DHCP is on, it attempts to assign an IP address to the instrument. If it fails, AutoIP attempts to assign an IP
l
address to the instrument.
Contact your LAN administrator to obtain an IP address.
l
This setting is non-volatile; it will not be changed by power cycling or *RST.
l
120 Agilent 33500 Series Operating and Service Guide