Agilent Technologies Agilent 33500 Series Operating And Service Manual page 123

Remote Interface Configuration
Finally, toggle the first softkey to Manual and press More and Gateway. Then set the appropriate gateway
address using the numeric keypad or knob.
SCPI: SYSTem:COMMunicate:LAN:GATeway "<address>"
l
Hostname
A hostname is the host portion of the domain name, which is translated into an IP address.
The instrument receives a unique hostname at the factory, but you may change it. The hostname must be unique
l
on the LAN.
Name must start with letter; other characters can be an upper or lower case letters, numeric digits, or dashes ("-
l
").
This setting is non-volatile; it will not be changed by power cycling or *RST.
l
Front Panel:
l
Finally, press Host Name and enter the hostname with the knob and cursor keys. The knob changes the char-
acter; cursor arrows move between characters.
SCPI: SYSTem:COMMunicate:LAN:HOSTname "<name>"
l
Domain Name
A domain name is a registered Internet name that gets translated into an IP address. You cannot set it from the front
panel or SCPI.
DNS Server
DNS (Domain Name Service) is an Internet service that translates domain names into IP addresses. The DNS server
address is the IP address of a server that performs this service.
Normally, DHCP discovers DNS address information; you only need to change this if DHCP is unused or not func-
l
tional. Contact your LAN administrator for DNS server details.
This setting is non-volatile; it will not be changed by power cycling or *RST.
l
Front Panel:
l
122 Agilent 33500 Series Operating and Service Guide