Agilent Technologies Agilent 33500 Series Operating And Service Manual page 188

2,repeat,maintain,5
FUNC ARB
FUNC:ARB seqExample
DATA:ATTR:POINTS? <--- result is 40, the sum of four 10-point arbs
DATA:ATTR:PTPEAK? <--- result is 0.5, only using half of 10 Vpp range
OUTPUT ON
Format for < arb_name >
Many DATA commands use the name of an arbitrary waveform. The following rules apply:
<arb_name> must match:
l
A waveform already loaded into waveform memory.
l
A waveform existing in INTERNAL or USB mass memory.
l
See MMEMory:LOAD:DATA[1|2], DATA:ARBitrary, or
l
[SOURce[1|2]:]DATA:ARBitrary2:FORMat {ABAB|AABB}
(Applies only to instruments with the optional IQ player capability.)
Specifies whether the format for data points in
all of channel 1 followed by all of channel 2 (AABB).
You may spell out the keyword ARBitrary2, but you must abbreviate it as ARB2. You can-
not abbreviate it as ARB.
Parameter
{AABB|ABAB}
Specify an interleaved data format for dual arbitrary waveform data:
DATA:ARB2:FORM ABAB
Agilent 33500 Series Operating and Service Guide
DATA:ARBitrary:DAC
DATA:ARB2 and
Typical Return
AABB or ABAB
for valid formats for <arb_name>.
DATA:ARB2:DAC commands is interleaved (ABAB) or
DATA Subsystem
187