Copy Logging Onboard Module - Cisco ME 3800X Command Reference Manual

copy logging onboard module

copy logging onboard module
To copy on-board failure logging (OBFL) data to the local network or a specific file system, use the copy
logging onboard module command in privileged EXEC mode.
Syntax Description slot-number
destination
Defaults
This command has no default setting.
Command Modes
Privileged EXEC
Command History Release
12.2(52)EY
Cisco ME 3800X and ME 3600X Switch Command Reference
2-50
copy logging onboard module [slot-number] destination
(Optional) The slot number is always 1 and is not relevant for the ME-3400E.
Specifies the location on the local network or file system to which the system
messages are copied.
For destination, specify the destination on the local or network file system and the
filename. These options are supported:
The syntax for the local flash file system:
•
flash:/filename
The syntax for the FTP:
•
ftp://username:password@host/filename
The syntax for an HTTP server:
•
http://[[username:password]@]{hostname | host-ip}[/directory]/filename
The syntax for the null file system:
•
null:/filename
The syntax for the NVRAM:
•
nvram:/filename
The syntax for the Remote Copy Protocol (RCP):
•
rcp://username@host/filename
• The syntax for the switch file system:
system:filename
• The syntax for the TFTP:
tftp:[[//location]/directory]/filename
The syntax for the temporary file system:
•
tmpsys:/filename
Modification
This command was introduced.
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
OL-28238-01