Cisco ME 3800X Command Reference Manual page 441

Chapter
Command Modes Global configuration
Command History Release
12.2(52)EY
Usage Guidelines Specify the host (NMS) that receives the traps by using the snmp-server host global configuration
command. If no trap types are specified, all trap types are sent.
When supported, use the snmp-server enable traps command to enable sending of traps or informs.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command
for each trap type.
SNMP transceiver traps apply to SFPs that support DoM-capable transceivers installed on the switch.
The sensor values are polled every 10 minutes, which is how often the user sees traps or alarms.
You can verify your setting by entering the show running-config privileged EXEC command.
Examples This example shows how to send MPLS traps to the NMS:
Switch(config)# snmp-server enable traps mpsl
Related Commands Command
show running-config
snmp-server host
OL-28238-01
Modification
This command was introduced.
Description
Displays the operating configuration.
Specifies the host that receives SNMP traps.
Cisco ME 3800X and ME 3600X Switch Command Reference
snmp-server enable traps
-7