Cisco ME 3800X Command Reference Manual page 367

Chapter
Table 3-12 show lacp counters Field Descriptions
Field
LACPDUs Sent and Recv
Marker Sent and Recv
Marker Response Sent and Recv
LACPDUs Pkts and Err
This is an example of output from the show lacp internal command:
Switch> show lacp 1 internal
Flags:
Channel group 1
Port
Gi0/1
Gi0/2
Table 2-17
Table 3-13 show lacp internal Field Descriptions
Field
State
LACP Port Priority
Admin Key
Oper Key
OL-28238-01
Description
The number of LACP packets sent and received by a port.
The number of LACP marker packets sent and received by a port.
The number of LACP marker response packets sent and received by a port.
The number of unknown and illegal packets received by LACP for a port.
S - Device is requesting Slow LACPDUs
F - Device is requesting Fast LACPDUs
A - Device is in Active mode
LACP port
Flags State Priority
SA bndl 32768
SA bndl 32768
describes the fields in the display.
Description
State of the specific port. These are the allowed values:
– —Port is in an unknown state.
•
bndl—Port is attached to an aggregator and bundled with other ports.
•
susp—Port is in a suspended state; it is not attached to any aggregator.
•
• hot-sby—Port is in a hot-standby state.
• indiv—Port is incapable of bundling with any other port.
• indep—Port is in an independent state (not bundled but able to switch data traffic.
In this case, LACP is not running on the partner port).
• down—Port is down.
Port priority setting. LACP uses the port priority to put ports s in standby mode when
there is a hardware limitation that prevents all compatible ports from aggregating.
Administrative key assigned to this port. LACP automatically generates an
administrative key value as a hexadecimal number. The administrative key defines the
ability of a port to aggregate with other ports. A port's ability to aggregate with other
ports is determined by the port physical characteristics (for example, data rate and
duplex capability) and configuration restrictions that you establish.
Runtime operational key that is being used by this port. LACP automatically generates
this value as a hexadecimal number.
P - Device is in Passive mode
Admin Oper
Key Key
0x3 0x3
0x3 0x3
Cisco ME 3800X and ME 3600X Switch Command Reference
show lacp
Port Port
Number State
0x4 0x3D
0x5 0x3D
-91