Lacp Rate - Cisco ME 3800X Command Reference Manual

Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands

lacp rate

To set the rate at which Link Aggregation Control Protocol (LACP) packets are ingressed to an interface,
lacp rate command in interface configuration mode. To return to the default setting, use the no form of
this command.
Syntax Description fast
normal
Defaults The default is normal.
Command Modes
Interface configuration
Command History
Release
15.3(1)S
Usage Guidelines The lacp rate fast interface configuration command can be used to assist with early detection of a
member link failure.
Use the show lacp internal priviledged EXEC command to show the rate flag. F indicates fast rate is
configured. A indicates the normal rate.
For information about configuring LACP on physical ports, see the "Configuring EtherChannels"
chapter in the software configuration guide for this release.
Examples This example shows how to enable fast rate on an interface:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# lacp rate fast
Related Commands Command
show lacp internal
OL-28238-01
lacp rate {fast | normal}
Sets the LACP packets to be ingressed at the rate of one second for this
interface.
The normal option returns rate of LACP ingressed packets to 30 seconds
once the link is established
Modification
This command was introduced.
Description
Displays internal information for all channel groups or for
the specified channel group.
Cisco ME 3800X and ME 3600X Switch Command Reference
lacp rate
2-135