Location (Global Configuration) - Cisco ME 3800X Command Reference Manual

location (global configuration)

location (global configuration)
To configure location information for a Link Layer Discovery Protocol (LLDP) endpoint, use the
location command in global configuration mode. To remove the location information, use the no form
of this command.
Syntax Description
admin-tag
civic-location
elin-location
identifier id
string
Defaults
This command has no default setting.
Command Modes Global configuration
Command History Release
12.(52)EY
Usage Guidelines
After entering the location civic-location identifier id global configuration command, you enter civic
location configuration mode. In this mode, you can enter the civic location and the postal location
information.
The civic-location identifier must not exceed 250 bytes.
Use the no lldp med-tlv-select location information interface configuration command to disable the
location TLV. The location TLV is enabled by default. For more information, see the "Configuring LLDP
and LLDP-MED" chapter of the software configuration guide for this release.
You can verify the configuration by entering the show location elin privileged EXEC command.
Cisco ME 3800X and ME 3600X Switch Command Reference
2-138
location {admin-tag string | civic-location identifier id | elin-location string identifier id}
no location {admin-tag string | civic-location identifier id | elin-location string identifier id}
Modification
This command was introduced.
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
Configures administrative tag or site information.
Configures civic location information.
Configures emergency location information (ELIN).
Specifies the ID for the civic location or the elin location. The ID range
is 1 to 4095.
The identifier for the civic location in the LLDP-MED TLV is
Note
limited to 250 bytes or less. To avoid error messages about
available buffer space during switch configuration, be sure that
the total length of all civic-location information specified for
each civic-location identifier does not exceed 250 bytes.
Specifies the site or location information in alphanumeric format.
OL-28238-01