Shutdown - Cisco ME 3800X Command Reference Manual

3 ]
Chapter

shutdown

To disable an interface or Ethernet flow point (EFP) service instance, use the shutdown command in
interface configuration or service-instance configuration mode. To restart a disabled interface or service
instance, use the no form of this command.
Syntax Description
This command has no arguments or keywords.
Command Modes
Interface configuration or service-instance configuration
Command History Release
12.2(52)EY
Usage Guidelines
The shutdown command causes a port or service instance to stop forwarding.
The no shutdown command has no effect if the port is a static-access port assigned to a VLAN that has
been deleted, suspended, or shut down. The port must first be a member of an active VLAN before it can
be re-enabled.
The shutdown command disables all functions on the specified interface or service instance.
This command also marks the interface. To see if an interface is disabled, use the show interfaces
privileged EXEC command. An interface that has been shut down is shown as administratively down in
the display.
Examples These examples show how to disable and re-enable a port and a service instance:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# shutdown
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# no shutdown
Switch (config)# interface gigabitethernet0/1
Switch (config-if)# service instance 1 Ethernet
Switch (config-if-srv)# shutdown
Switch (config)# interface gigabitethernet0/1
Switch (config-if)# service instance 1 Ethernet
Switch (config-if-srv)# no shutdown
Related Commands Command
show interfaces
OL-28238-01
shutdown
no shutdown
Modification
This command was introduced.
Description
Displays the statistical information for all interfaces or for a specific interface.
Cisco ME 3800X and ME 3600X Switch Command Reference
shutdown
-1