Ethernet Y1731 Delay - Cisco ME 3800X Command Reference Manual

ethernet y1731 delay

ethernet y1731 delay
To configure a sender Maintenance End Point (MEP) for an IP Service Level Agreements (SLAs) Metro
Ethernet 3.0 (UIT-T Y.1731) delay or delay variation operation, use the ethernet y1731delay command
in IP SLA configuration mode.
ethernet y1731 delay DMM domain domain {{vlan | evc} value}{mpid | mac-address} value cos
value source {mpid | mac-address} value
Syntax Description
DMM
domain domain
vlan
evc
mpid
mac-address
cos
source mpid
source mac-address
Defaults A sender MEP is not configured for theiP SLAs Metro-Ethernet 3.0 (ITU-T Y.1731) operation.
Command Modes
IP SLA configuration (config-ip-sla)
Command History Release
15.2(4)S
Usage Guidelines
This command begins configuring a sender MEP for an Ethernet Frame Delay (ETH-DM: FD) operation
and enters IP SLA Y.1731 delay configuration mode.
The DMM keyword for this command is not case sensitive. The keyword in online help contains
uppercase letters to enhance readability only.
To change the operation type of an existing IP SLAs operation, you must first use the no ip sla command
to delete the IP SLAs operation and then reconfigure the iperation with the new operation type.
Examples This example shows how configure an MEP for a two way frame delay or delay variation operation.
Cisco ME 3800X and ME 3600X Switch Command Reference
2-76
Chapter 2
Specifies that the frames sent are Delay Measurement Message (DMM)
synthetic frames.
Specifies name of the Ethernet Connectivity Fault Management (CFM)
maintenance domain.
Specifies the VLAN identification number. The range is from 1 to 4096.
Specifies the Ethernet Virtual Circuit (EVC) identification name.
Specifies the maintenance endpoint identification numbers of the MEP
at the destination. The range is from 1 to 8191.
Specifies the MAC address of the MEP at the destination.
Specifies, for this MEP, which class of service (CoS) that will be sent
in the Ethernet connectivity fault management (CFM) message. The
range is from 0 to 7.
List of maintenance endpoint identification numbers of the MEP being
configured. The range is from 1 to 8191.
MAC address of the MEP being configured.
Modification
This command was introduced.
Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
OL-28238-01