Cisco ME 3800X Command Reference Manual page 93

Hide thumbs Also See for ME 3800X:
Table of Contents

Advertisement

Chapter 2
Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
interval interval
Although visible in the command-line interface help, the arp-inspection, security-violation, and vmps
Note
keywords are not supported.
Defaults
Recovery is disabled for all causes.
The default recovery interval is 300 seconds.
Command Modes
Global configuration
Command History
Release
12.2(52)EY
Usage Guidelines
A cause (all, bpduguard and so forth) is defined as the reason that the error-disabled state occurred.
When a cause is detected on an interface, the interface is placed in error-disabled state, an operational
state similar to link-down state. If you do not enable errdisable recovery for the cause, the interface stays
in error-disabled state until you enter a shutdown and no shutdown interface configuration command.
If you enable the recovery for a cause, the interface is brought out of the error-disabled state and allowed
to retry the operation again when all the causes have timed out.
Otherwise, you must enter the shutdown then no shutdown commands to manually recover an interface
from the error-disabled state
You can verify your settings by entering the show errdisable recovery privileged EXEC command.
Examples
This example shows how to enable the recovery timer for the BPDU guard error-disabled cause:
Switch(config)# errdisable recovery cause bpduguard
This example shows how to set the timer to 500 seconds:
Switch(config)# errdisable recovery interval 500
OL-28238-01
Specifies the time to recover from the specified error-disabled state. The
range is 30 to 86400 seconds. The same interval is applied to all causes. The
default interval is 300 seconds.
The error-disabled recovery timer is initialized at a random
Note
differential from the configured interval value. The difference
between the actual timeout value and the configured value can be up
to 15 percent of the configured interval.
Modification
This command was introduced.
Cisco ME 3800X and ME 3600X Switch Command Reference
errdisable recovery
2-69

Advertisement

Table of Contents
loading

This manual is also suitable for:

Me 3600x

Table of Contents