Show Vfi - Cisco ME 3800X Command Reference Manual

show vfi

show vfi
To display information about a virtual forwarding infrastructure (VFI), use the show vfi command in
user EXEC mode. VFIs are used to implement hierarchical virtual private LAN service (H-VPLS) over
a multiprotocol label switching (MPLS) backbone.
Syntax Description vfi-name
forwarding
| begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2.(52)EY
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show vfi command:
Switch> show vfi vfitest1
VFI name:vfitest1, state:UP
Local attachment circuits:
Neighbor connected via pseudowires:11.11.11.11
This is an example of output from the show vfi command with the forwarding keyword:
Switch> show vfi vfitest1 forwarding
vcid:222, type:ether , local groupid:37, remote groupid:40 (vc is up)
client:Vfi is up, destination:11.11.11.11, Peer LDP Ident:11.11.11.11:0
local label:20, remote label:21, tunnel label:implc-null
outgoing interface:Gi1/1/2, next hop:2.2.2.1
Local MTU:1500, Remote MTU:1500
Remote interface description:Vfi
Packet totals(in/out):10/3375408
byte totals(in/out):1306/276783942
Cisco ME 3800X and ME 3600X Switch Command Reference
-152
show vfi vfi-name [ forwarding] [ | {begin | exclude | include} expression]
Name of the configured VFI.
(Optional) Displays the VFI Layer 2 forwarding table.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Vlan666
Chapter
OL-28238-01