Ethernet Evc - Cisco ME 3800X Command Reference Manual

Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands

ethernet evc

To define an Ethernet virtual connection (EVC) and to enter EVC configuration mode, use the ethernet
evc command in global configuration mode.To delete the EVC, use the no form of this command.
Syntax Description
evc-id
Defaults No EVCs are defined.
Command Modes Global configuration
Command History Release
12.2(52)EY
Usage Guidelines After you enter the ethernet evc evc-id command, the switch enters EVC configuration mode, and these
configuration commands are available:
•
•
•
•
•
Examples This example shows how to define an EVC and to enter EVC configuration mode:
Switch(config)# ethernet evc test1
Switch(config-evc)#
Related Commands Command
service instance id ethernet
evc-id
show ethernet service evc
OL-28238-01
ethernet evc evc-id
no ethernet evc evc-id
The EVC identifier. This can be a string of from 1 to 100 characters.
Modification
This command was introduced.
default: sets the EVC to its default states.
exit: exits EVC configuration mode and returns to global configuration mode.
no: negates a command or returns a command to its default setting.
oam protocol cfm svlan: configures the Ethernet operation, administration, and maintenance
(OAM) protocol as IEEE 802.1ag Connectivity Fault Management (CFM) and sets parameters. See
the oam protocol cfm svlan
uni count: configures a UNI count for the EVC. See the
command.
Description
Configures an Ethernet service instance and attaches an EVC to it.
Displays information about configured EVCs.
Cisco ME 3800X and ME 3600X Switch Command Reference
uni count command.
ethernet evc
2-71