show errdisable recovery
show errdisable recovery
To display the error-disable recovery timer information, use the show errdisable recovery command in
user EXEC mode.
Syntax Description
| begin
| exclude
| include
expression
Command Modes
User EXEC
Command History
Release
12.2(52)EY
Usage Guidelines
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
A gbic-invalid error-disable reason refers to an invalid small form-factor pluggable (SFP) module
interface.
Examples
This is an example of output from the show errdisable recovery command:
Switch> show errdisable recovery
ErrDisable Reason
-----------------
arp-inspection
bpduguard
channel-misconfig (STP)
dhcp-rate-limit
dtp-flap
gbic-invalid
link-flap
mac-limit
link-monitor-failure
loopback
oam-remote-failure
pagp-flap
port-mode-failure
pppoe-ia-rate-limit
psecure-violation
security-violation
sfp-config-mismatch
storm-control
udld
vmps
Cisco ME 3800X and ME 3600X Switch Command Reference
-56
show errdisable recovery [ | {begin | exclude | include} expression]
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Timer Status
--------------
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Chapter
OL-28238-01