Cisco ME 3800X Command Reference Manual page 341

Chapter
| begin
| exclude
| include
expression
Though visible in the command-line help strings, the crb, private-vlan mapping, pruning
Note
random-detect, and rate-limit keywords are not supported.
Command Modes Privileged EXEC
Command History Release
12.2(52)EY
Usage Guidelines
The show interfaces capabilities command with different keywords has these results:
•
•
•
•
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples
This is an example of output from the show interfaces command for an interface:
Switch# show interfaces gigabitethernet0/1
GigabitEthernet0/1 is up, line protocol is up (connected)
Hardware is Gigabit Ethernet, address is 0023.eb17.c781 (bia 0023.eb17.c781)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 1000Mb/s, link type is auto, media type is 10/100/1000BaseTX SFP
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:00:14, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/0 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
OL-28238-01
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Use the show interface capabilities module 1 to display the capabilities of all interfaces on the
switch. Entering any other number is invalid.
Use the show interfaces interface-id capabilities to display the capabilities of the specified
interface.
Use the show interfaces capabilities (with no module number or interface ID) to display the
capabilities of all interfaces on the switch.
Use the show interface switchport module 1 to display the switch port characteristics of all
interfaces on the switch. Entering any other number is invalid.
reliability 255/255, txload 1/255, rxload 1/255
28980 packets input, 2882755 bytes, 0 no buffer
Cisco ME 3800X and ME 3600X Switch Command Reference
show interfaces
-65