Configuring Module And Facility Messages Logging - Cisco Nexus 3548 series Configuration Manual

Configuring System Message Logging
cert_enroll
...

Configuring Module and Facility Messages Logging

You can configure the severity level and time-stamp units of messages logged by modules and facilities.
Procedure
Step 1
Step 2
Step 3
2
Command or Action
switch# configure terminal
switch(config)# logging module [severity-level]
switch(config)# logging level facility
severity-level
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 7.x
Configuring Module and Facility Messages Logging
2
Purpose
Enters global configuration mode.
Enables module log messages that have the
specified severity level or higher. Severity levels
range from 0 to 7:
• 0 – emergency
• 1 – alert
• 2 – critical
• 3 – error
• 4 – warning
• 5 – notification
• 6 – informational
• 7 – debugging
If the severity level is not specified, the default
of 5 is used.
Enables logging messages from the specified
facility that have the specified severity level or
higher. Severity levels from 0 to 7:
• 0 – emergency
• 1 – alert
• 2 – critical
• 3 – error
• 4 – warning
• 5 – notification
• 6 – informational
• 7 – debugging
41