T.38 Settings; Outgoing/Incoming E-Mail Settings - Fuji Xerox ApeosPort-V 3065 Administrator's Manual

T.38 Settings

Configure the settings for T.38.
T.38 Transport Protocol
Select T.38 transport protocol from [TCP] or [UDP].
Note
When you use VoIP gateway manufactured by Cisco Systems, Inc., select [UDP].
UDPTL Listening Port Number
Set the UDPTL listening port number from 1 to 65535.
Important
Do not use any numbers assigned to other ports.
TCP Listening Port Number
Set the TCP listening port number from 1 to 65535.
Important
Do not use any numbers assigned to other ports.
RTP Listening Port Number
Set the RTP listening port number from 1 to 65535.
Important
Do not use any numbers assigned to other ports.
Prioritize IP Packets / Prioritize IP Packets (Ethernet 1), Prioritize IP Packets
(Ethernet 2)
Set the priority of IP packet transmission from 0 to 255.
Note
The value set varies depending on your environment. Consult your network administrator.
Set the value already specified by the network side. If you set other values, the priority does not change.
(For most of Cisco® routers, speech traffic is set to 184(ef). If you change the value, consult your network
administrator.)
The title of this setting item differs depending on the Ethernet interface configuration: When single Ethernet
interface is used, [Prioritize IP Packets] is displayed. When two Ethernet interfaces are used, [Prioritize IP
Packets (Ethernet 1)] and [Prioritize IP Packets (Ethernet 2)] are displayed.
When any interface names are specified in [Ethernet1 - Network Name] and [Ethernet2 - Network Name], the
specified names are displayed instead of "Ethernet1" and "Ethernet2" of [Prioritize IP Packets (Ethernet 1)]
and [Prioritize IP Packets (Ethernet 2)] respectively.

Outgoing/Incoming E-mail Settings

Set e-mail transmission and reception settings.
Connectivity & Network Setup
189
5