Power Saver Settings - Fuji Xerox ApeosPort-V 3065 Administrator's Manual

Tools
Print-On-Demand Duration
Specify the duration for the machine to receive a print job from web applications. Unless
the machine receives full data of the print job within the specified period of time, the
machine does not process the print job.
Specify the time duration between 0 and 255 minutes in 1 minute increments. If you
specify [0], it means that there is no time limit set on the machine for receiving data.
Note

Power Saver Settings

You can configure the following settings of Power Saver mode.
Power Saver Timers
The Power Saver mode has two modes: the Low Power and Sleep modes. When a specified
period of time has elapsed, the machine switches to these modes in the following order to
reduce power consumption.
5
Last operation on the machine
Reference
Note
From Last Operation to Low Power Mode
Specify a time period between 1 and 240 minutes in 1 minute increments to enter the Low
Power mode after the last operation.
From Last Operation to Sleep Mode
Specify a time period between 1 to 240 minutes in 1 minute increments to enter the Sleep
mode after the last operation.
Note
Power Saver Deactivation
Select whether to disable the Power Saver mode fully or partially when exiting the mode.
Deactivate All
All devices of the machine exit the Power Saver mode.
Deactivate Partially As Required
Only the devices necessary for the operation exit the Power Saver mode.
You can select from [Always On] or [When Printing / Job Auto Processing].
130
When you send a print job that contains a large amount of data or a print job whose contents take a while to
be processed, transmission may be timed out before the machine receives the last page of the print job. If
transmission is timed out, the print job will be canceled. Therefore, you should consider the machine usage
when you set the time duration.
This feature is available only for the ApeosPort Series models.
For more information on the setting procedure, refer to "Power Saver Mode" (P.23).
You cannot configure the machine not to switch to the Low Power mode or the Sleep mode.
Configure the [From Last Operation to Sleep Mode] time to be same or longer than the [From Last Operation
to Low Power Mode] time.
The machine enters Sleep mode without entering Low Power mode when the [From Last Operation to Low
Power Mode] time is same as the [From Last Operation to Sleep Mode] time.
Low Power mode Sleep mode