Step 3 Configuration On The Computer - Fuji Xerox ApeosPort-V 3065 Administrator's Manual

Printer Environment Settings
6) Select [Close] repeatedly until the [Tools] screen is displayed.
3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
address. The configuration of an IP address, a subnet mask, and a gateway address is not
required.
Reference
4
If the operating system on the client is Mac OS X 10.6 or later, enable the Bonjour port, and
the Discovery feature that automatically detects printers on the IP network can be enabled.
Note
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [Bonjour], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
5
Select [Close] repeatedly until the [Tools] screen is displayed.
6
7
Select [Close].
Note
7
Print a configuration report to confirm that the LPD port is enabled and that TCP/IP is set
up correctly.
Reference
8
Configure other LPD or Port 9100 settings as necessary.
Reference

Step 3 Configuration on the Computer

To print from the machine, you need to install a print driver on your computer.
Reference
324
For information on how to set an IP address, refer to "Protocol Settings" (P.177).
To print from a printer detected by Bonjour, the LPD port must be enabled in advance.
Rebooting the machine may be required depending on the settings. When a message displayed on the
screen, follow the message and reboot the machine.
For information on how to print a configuration report, refer to "Print Reports" (P.95).
For information on how to set up the LPD port or Port 9100, refer to "CentreWare Internet Services Setting Items" (P.325).
For information on the supported operating systems, refer to Supported Operating Systems(P.319).
For information on the driver installation procedures, refer to the manual contained in the Media (Software/
Product Manual).
You can print via TCP/IP (LPD) from a Macintosh computer for Mac OS X 10.5/10.6, Mac OS X 10.7 Lion, OS X
10.8 Mountain Lion, OS X 10.9 Mavericks, and OS X 10.10 Yosemite. For information on the installation
procedures of the print driver for Mac OS X, refer to the manual contained in the Media provided with the
driver.