Configuration Of Network Scanning (Job Template Scanning); Step 1 Preparations; Step 2 Enabling Ports And Setting Up Tcp/Ip - Fuji Xerox ApeosPort-V 3065 Administrator's Manual

Scanner Environment Settings
Configuration of Network Scanning (Job Template
Scanning)
This section describes how to configure the machine to use the Network Scanning service.
The following shows the reference section for each procedure.
"Step 1 Preparations" (P.356)
"Step 2 Enabling Ports and Setting up TCP/IP" (P.356)
"Step 3 Configuring the SNMP Port" (P.357)
"Step 4 Configuration on the Computer" (P.358)

Step 1 Preparations

The following environment is required to use the Network Scanning feature on the
machine.
9

Step 2 Enabling Ports and Setting up TCP/IP

To use Network Scanning service, enable the port and set the IP address. The following
describes the configuration procedures on the machine.
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
356
To use SMB forwarding, your computer must run on one of the following operating
systems that supports folder sharing.
- Microsoft Windows NT 4.0
- Microsoft Windows 2000
- Microsoft Windows Server 2003
- Microsoft Windows Server 2008
- Microsoft Windows Server 2008 R2
- Microsoft Windows Server 2012
- Microsoft Windows Server 2012 R2
- Microsoft Windows Vista
- Microsoft Windows 7
- Microsoft Windows 8
- Microsoft Windows 8.1
You can configure the settings using CentreWare Internet Services. For information on how to use
CentreWare Internet Services, refer to "Configuring Machine Settings Using CentreWare Internet Services"
(P.313).