Notes And Restrictions For Using Tcp/Ip - Fuji Xerox ApeosPort-V 3065 Administrator's Manual

SMB Authentication
When an IP address or a host name is used to designate the authentication server for SMB
authentication, even if the domain name is incorrect, the authentication succeeds if the
correct user name and passcode are entered.

Notes and Restrictions for Using TCP/IP

This section describes notes and restrictions to observe when using TCP/IP (LPD).
Configuration on the Computer
IP addresses are managed for the entire system. Configure the settings only after
consulting your network administrator.
When setting the network such as IP addresses with a host used under the Network
Information Service (NIS), consult your NIS administrator.
Turning Off the Machine
Check the following points when turning off the machine:
When [Receiving Buffer - LPD] is set to [Spool to Memory
All print data spooled within the machine memory, including the data which is being
printed, is erased. The print data does not remain when the machine is turned on again.
However, if the machine was turned off immediately after a computer instructed a print
job, the job may remain on the computer. In this case, when the machine is turned on,
the data stored on the computer is printed before any jobs instructed subsequently.
When [Receiving Buffer - LPD] is set to [Spool to Hard Disk]
All print data spooled in the machine hard disk, including the data which is being printed,
is saved. In this case, when the machine is turned on, the data stored on the machine
hard disk is printed before any jobs instructed subsequently.
When [Receiving Buffer - LPD] is set to [No Spooling]
All print data spooled in the machine receiving buffer, including the data which is being
printed, is erased. The print data does not remain when the machine is turned on again.
However, if the machine was turned off immediately after a computer instructed a print
job, the job may remain on the computer. In this case, when the machine is turned on,
the data stored on the computer is printed before any jobs instructed subsequently.
While Printing
When [Receiving Buffer - LPD] is set to either [Spool to Hard Disk] or [Spool to Memory]
If the transmitted print data size exceeds the available capacity of either hard disk or
memory, the print data is not received.
Note
When the print data exceeds the receivable size, some computers may immediately re-transmit the print
data. In this case, the computer appears to be not operating. Remedy this problem by canceling the print
data transmission from the computer.
When [Receiving Buffer - LPD] is set to [No Spooling]
When the machine receives a print request from a computer, the machine cannot accept
print requests from any other computers.
When a computer's IP address or a computer name is changed
Notes and Restrictions
717
16