T.38 Settings; Outgoing/Incoming E-Mail Settings - Fuji Xerox ApeosPort-IV C5575 Administration Manual

5 Tools
VoIP Gateway Setup
You can configure the following settings for VoIP Gateway 1 to 50.
You can also configure different VoIP gateways by a recipient's telephone number.
Note
ID
Specify a number to identify the recipients' telephone numbers.
If you specify "03", this VoIP gateway is used for the telephone numbers beginning with "03"
such as "0312345678" and "0312345679".
Note
Gateway Address
Enter the IP address of the VoIP gateway.

T.38 Settings

Configure the settings for T.38.
5
T.38 Transport Protocol
Select T.38 transport protocol from [TCP] or [UDP].
Note
T.38 - UDPTL Listening Port Number
Set the UDPTL listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
T.38 - TCP Listening Port Number
Set the TCP listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
T.38 - RTP Listening Port Number
Set the RTP listening port number from 1 to 65535.
Important • Do not use any numbers assigned to other ports.
Prioritize T.38 IP Packets
Set the priority of IP packet transmission from 0 to 255.
Note

Outgoing/Incoming E-mail Settings

Set e-mail transmission and reception settings.
210
• To use a fixed VoIP gateway, do not register the ID, and specify only the IP address for VoIP
Gateway 1.
• You cannot use a VoIP gateway in an IPv6 network.
• If you specify a specific telephone number, specify the entire telephone number such as
"0312345678".
• When you use VoIP gateway manufactured by Cisco Systems, Inc., select [UDP].
• The value set varies depending on your environment. Consult your network administrator.
• Set the value already specified by the network side. If you set other values, the priority does not
change.
(For most of Cisco routers, speech traffic is set to 184(ef). If you change the value, consult your
network administrator.)