PDT 8100 Series with Windows Mobile 2003 Software for Pocket PCs Product Reference Guide
After recharging, power on the terminal with the Power button. The Power button is the only
wake-up source for the terminal after the battery door is removed and reinstalled, or after a
battery fault condition (such as when the terminal suspends due to a very low battery).
Once the terminal is resumed with the Power button, all selected wake-up sources (see
Configuring Wake-up
Note: The battery can also be recharged separately in the CRD 8100-
1200S Single Slot Serial/Charging Cradle, VCD 8100-R001 Vehicle
Charging Cradle, or UBC battery adapter.
Using the Serial/Charging Cable
To charge the battery in the terminal using the optional Serial/Charging Cable:
1. Insert the cable into the bottom of the terminal
Figure 1-6. Inserting the Serial/Charging Cable in the Terminal
1-14
on page 1-32) can be used as configured.
(Figure
1-6).
Serial/Charging
Cable