Performing A Hard Reset - Symbol PDT 8100 Series Product Reference Manual

Performing a Hard Reset

A hard reset (cold boot) also restarts the terminal, but can erase all files and settings not
stored in the Flash File System. Therefore, never perform a hard reset unless a soft reset
does not solve the problem.
Note: You can restore any data previously synchronized with the computer
during the next ActiveSync operation. See
Charging Cable with ActiveSync
To perform a hard reset:
1. Remove the battery cover.
2. While holding down the Function key, use the tip of the stylus (or similar object
without a sharp tip) to gently press the Reset button.
3. Replace the battery cover and press the Power button.
4. As the terminal initializes its Flash File System, the Symbol splash screen displays
for about 30 seconds.
5. See Aligning the Screen
Note: With a hard reset, formats, preferences, and other settings are
restored to their factory default settings.
Function key
(37-key keyboard
pictured)
Figure 2-25. Hard Reset (Cold Boot) Buttons
on page 1-29 to perform an initial setup of the terminal.
Using the Serial/
on page 4-6.
Operating the Terminal
Reset button
2-35