PDT 8100 Series with Intel XScale Technology Product Reference Guide
After recharging, power on the terminal with the Power button. The Power button is the only
wake-up source for the terminal after the battery door is removed and reinstalled, or after a
battery fault condition (such as when the terminal suspends due to a very low battery).
Once the terminal is resumed with the Power button, all selected wake-up sources (see
Configuring Wake-up
Note: The battery can also be recharged separately in the CRD 8100-
1200S Single Slot Serial/Charging Cradle (1950 mAh battery only),
VCD 8100-R001 Vehicle Charging Cradle (1950 mAh battery only),
or UBC battery adapter (1950 mAh and 3000 mAh battery).
Using the Serial/Charging Cable
To charge the battery in the terminal using the optional Serial/Charging Cable:
1. Insert the cable into the bottom of the terminal
Figure 1-6. Inserting the Serial/Charging Cable in the Terminal
1-14
on page 1-32) can be used as configured.
(Figure
1-6).
Serial/Charging
Cable