Symbol PDT 8100 Series Product Reference Manual page 278

PDT 8100 Series with Windows Mobile 2003 Software for Pocket PCs Product Reference Guide
Table 12-1. Troubleshooting The Terminal (continued)
Problem
During data communication, no
data was transmitted, or
transmitted data was
incomplete.
No sound is audible.
Terminal turns itself off.
12-6
Cause
Terminal removed from cradle
or unplugged from host PC
during communications.
Incorrect cable configuration.
Communication software was
incorrectly installed or
configured.
Volume setting is low or turned
off.
Terminal is inactive.
Battery is depleted.
Battery cover is removed.
Solution
Replace the terminal in the
cradle, or replace the
Synchronization cable, and re-
transmit.
See your System Administrator.
Perform setup as described in
Chapter 4, Communications.
Check the System Volume
slider in the Sounds &
Reminders properties dialog
box (tap Start - Settings) to
ensure the volume is not turned
down.
The terminal turns off after a
period of inactivity. If the
terminal is running on battery
power, this period can be set
from 1 to 5 minutes, in one-
minute intervals. If the terminal
is running on external power,
this period can be set to 1, 2, 5,
10, 15, and 30 minutes.
Check the Power dialog box
(tap Start - Settings - System tab
- Power), and change the
setting if you need a longer
delay before the automatic
shutoff feature activates.
Replace the battery.
Replace the battery door.