Symbol PDT 8100 Series Product Reference Manual page 124

PDT 8100 Series with Windows Mobile 2003 Software for Pocket PCs Product Reference Guide
2. Press 1 to display the Public network settings menu
3. At the Public network settings menu:
a. Press 1 and set Static Mode to 0.
b. Set the DHCP Address Mode as follows:
• For the 6 DHCP Address Mode:
Press 2 and set NAPT Mode to 0.
When Static Mode and NAPT Mode are both set to 0, the cradle acquires 6
IP addresses from the DHCP server.
• For the 1 DHCP Address NAPT Mode:
Press 2 and set NAPT Mode to 1.
When the NAPT Mode is set to 1, the cradle uses 5 NAPT addresses
192.168.1.1 through 192.168.1.5 by default; your network will not see these
addresses).
c. Press Q to return to the main Cradle Utilities menu.
d. Press F to write these values to Flash memory and reset the cradle.
To configure the cradle to use the Static Address Mode:
1. Start a Terminal Emulation session for the cradle:
4-28
Public Network settings:
1: Static mode: 1
2: NAPT Mode: 1
The following settings are only used when Static
mode is 1:
3: Cradle IP Address: 0.0.0.0
4: Router (Gateway) IP Address: 0.0.0.0
5: 1st DNS IP Address: 0.0.0.0
6: 2nd DNS IP Address: 0.0.0.0
7: 1st WINS IP Address: 0.0.0.0
8: 2nd WINS IP Address: 0.0.0.0
9: Subnet mask: 0.0.0.0
The following settings are only used when NAPT
mode is 0 and Static mode is 1:
A: Terminal 1 IP Address: 0.0.0.0
B: Terminal 2 IP Address: 0.0.0.0
C: Terminal 3 IP Address: 0.0.0.0
D: Terminal 4 IP Address: 0.0.0.0
E: Expansion Port IP Address: 0.0.0.0
: