Configuring Wake-Up - Symbol PDT 8100 Series Product Reference Manual
With windows mobile 2003 software for pocket pcs
Hide thumbs
Also See for PDT 8100 Series:
- Product reference manual (358 pages) ,
- Supported equipment manual (102 pages) ,
- Quick reference manual (48 pages)
Table of Contents
Advertisement
PDT 8100 Series with Windows Mobile 2003 Software for Pocket PCs Product Reference Guide
Configuring Wake-up
The terminal can be configured to wake-up by pressing the Scan trigger or any key on the
keypad. To set up this configuration:
1. Tap Start - Settings - System tab - Symbol Settings.
2. Use the Wakeups tab to configure the wake-up source for the terminal.
a. Under Power Off select the items to configure wake-ups when the terminal is
powered off.
b. Under Auto Off select the items to configure wake-ups when the terminal turns
off after a set period of time (this time can be set in Start - Settings - System tab
- Power).
Note: The Power button is the only wake-up source for the terminal after
the battery door is removed and reinstalled, or after a battery fault
condition (such as when the terminal suspends due to a very low
battery). Once the terminal is resumed with the Power button, all
selected wake-up sources can be used as configured.
1-32
Advertisement
Table of Contents
