Symbol PDT 8100 Series Product Reference Manual page 126

PDT 8100 Series with Windows Mobile 2003 Software for Pocket PCs Product Reference Guide
b. Press 2 and set the NAPT Mode to 0.
c. Press 3, and set the cradle IP address.
d. Press 4 and set the Router IP address to the IP address of your internet
gateway.
e. Use options 5 and 6 to set the DNS IP (server) addresses.
f. Use options 7 and 8 to set the WINS IP (server) addresses. This is required for
ActiveSync to function properly.
g. Press 9 and set the correct subnet mask for your subnet.
h. Press A, B, C, D, and E to set the 4 slot and expansion port IP addresses.
Using ActiveSync
1. On the terminal, tap Start - Settings - System - eConnect and ensure the following
settings are made:
Figure 4-12. eConnect Settings - Ethernet ActiveSync Setup
2. Tap the OK button.
3. Insert the terminal into the cradle. The cradle's communication LED turns red, then
flashes green, indicating that the host computer and terminal are communicating.
See Communication LED Indicator
4. On the terminal, a succession of dialog boxes appear, indicating the status of the
connection. When successfully connected and synchronized, the status of the host
computer is Connected/Synchronized.
4-30
on page 4-32 for other indications.