PDT 8000 Series with Windows
It is not recommended to use RF communication when the battery is
charging. For communication setup, see
Configuration.
Using the Serial Charging Cable
To charge the terminal's battery using the Serial Charging Cable, setup as shown below:
Figure 1-4. Attaching the Serial Charging Cable to the Terminal
The terminal charge LED blinks amber to indicate that the terminal battery is charging and
turns solid amber when charging is complete. The battery fully charges in less than four
hours, if the terminal is not in use. See
indications.
1-10
®
Mobile 2003 Software for Pocket PCs Product Reference Guide
Caution
Chapter 9, Spectrum24 Network
Serial Charging
Cable
Charge LED Indicator
Terminal
Charge LED
on page 1-22 for other