Toshiba e-STUDIO281c Service Manual page 375

(4) Remove 1 E-ring and 1 bushing from the exit
roller front side.
(5) Remove E-ring, gear unit, E-ring and bush-
ing in order from the exit roller rear side.
Then take off the exit roller.
[M] Discharge brush
(1) Take off the fuser unit
( P.16-19 "[A] Fuser unit").
(2) Remove 2 screws and take off the jam
access cover.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Bushing
E-ring
Fig. 16-52
Gear unit
E-ring
Fig. 16-53
Fig. 16-54
16 - 33
E-ring
Exit roller
Bushing
Jam access cover
e-STUDIO281c/351c/451c
FUSER UNIT / PAPER EXIT SECTION
16