Toshiba e-STUDIO281c Service Manual page 289

Hide thumbs Also See for e-STUDIO281c:

Table of Contents

Remove 3 screws and take off the rear

Front side: Remove the following parts

installed on the shaft of the developer sleeve

in order: Bushing, collar, roller (bearing-1), E-

ring, bearing-2 and oil seal.

* Procedure for replacing an oil seal:

P.12-32 "Fig. 12-63 "

Rear side: Remove the following parts

installed on the shaft of the developer sleeve

in order: E-ring, bushing, collar, roller (bear-

ing-1), E-ring, gear, pin, bearing-2 and oil

e-STUDIO281c/351c/451c

DEVELOPER UNIT

E-studio351c E-studio451c