Toshiba e-STUDIO281c Service Manual page 334

(4) Remove 1 screw and the pin on the front
side.
(5) Remove 1 screw and the pin on the rear
side.
(6) Take off the case.
[L] 2nd transfer roller position detection sensor (S18)
(1) Take off the case (
(2) Disconnect 1 connector and release 2
latches and take off the 2nd transfer roller
position detection sensor.
Note:
When reassembling the 2nd transfer cam-
shaft unit, make sure to align the phase of
the partial gear and the cam as shown in the
figure. If the partial gear is incorrectly
installed in a 180-degree reversed position,
an operation abnormality (CEC0: 2nd trans-
fer belt position detection abnormality) may
occur.
e-STUDIO281c/351c/451c
TRANSFER UNIT
P.14-17 "[K] Case").
14 - 18
Case
Pin
Fig. 14-33
2nd transfer roller
position detection sensor
Fig. 14-34
Cam
Partial gear
Fig. 14-35
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Pin